Sunday, April 7, 2013
Browse »
home»
circuit
»
remote
»
tester
»
tv
»
TV Remote Tester Circuit
Following the specification of components installed
Transistor BC557
TSOP 1738 Sensor Infra Red
R1 = 10k ohm ¼ watt Resistor
R2 = 1k ohm ¼ watt Resistor
R3 = 1k ohm ¼ watt Resistor
BZ = piezo disc
led
TV Remote Tester Circuit
The circuit is very effective to test the remote controls what still works or not, the remote record will be tested using infra red. Examples of the TV remote, AC and others. Please try I am sure 100% will be successful.
TV Remote Tester Circuit |
The workings of the circuit is very simple, when the infra red sensor receive infrared signals pin 2 sensor will produce a voltage, this voltage will drives the PNP transistor so that the LED lamp and piezo disc (BZ) is active. for the power supply you can use a 9 volt battery and then use IC 7805 or use 1.5 volt batteries x 3
Following the specification of components installed
Transistor BC557
TSOP 1738 Sensor Infra Red
R1 = 10k ohm ¼ watt Resistor
R2 = 1k ohm ¼ watt Resistor
R3 = 1k ohm ¼ watt Resistor
BZ = piezo disc
led
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.